Contents:
General use
Start a new test
Enable COM port
Display an existing measurement
Printing
Additional Help
General Use
The first time using the module, you should link the "Open Audiogram Module" tool button to Oscilla NOAH Module:
Go to "Tools" --> "Module Buttons".
Select "Oscilla NOAH Module".
Click "OK".
Select a client.
The Oscilla NOAH Module can then be started through the "Open Audiogram Module" tool button or the "Module Selection" tool button:
After starting the module the following is displayed.
If you want to start a new measurement, click
here
If you want to display an existing measurement, click
here
Back to top
Start a new test
Select instrument from the drop-down list.
Click "New".
The module will launch AudioConsole.
If you are using an Oscilla SM or TSM instrument, you must
enable a COM port in AudioConsole
.
When finished in AudioConsole, close by clicking the cross in the upper-right corner.
Back to top
Enable COM Port
Go to the Settings window in AudioConsole.
On the General tab page, click the checkbox to enable COM port A and/or B.
Click OK.
Back to top
Display an existing measurement
Start the module. This can either be done by double-clicking a measurement from the "Session Browser" or clicking the "Open Audiogram Module".
Select a measurement from the list of measurements as depicted below.
Click "Display".
Back to top
Printing
You can print a measurement from within AudioConsole.
Click the tool button "Print" as depicted below.
Back to top
For additional assistance contact the Oscilla NOAH Module development team
development@inmedico.com
Back to top
Inmedico A/S
